HCG Reconstitution Instructions

Open the 10ml syringe and gently but firmly tighten the needle hub in order to ensure that there is an airtight seal on the syringe/needle assembly. Take the bottle labeled Chorionic Gonadotropin and remove the plastic cap.

Insert the needle into the bottle carefully through the rubber stopper. DO NOT PUT THE NEEDLE INTO THE POWDER!

Gently draw the plunger back to the number 6 on the barrel and remove needle from the vial. This is to remove 6 ml’s of air from the vial of HCG in order to make room for the Bacteriostatic Water.

After doing this, take the second vial which is labeled Bacteriostatic Water and remove its’ plastic cap. Insert needle into the rubber stopper and inject the vial with 4-5ml’s of air (this introduces positive pressure into the vial). By doing this, you allow the proper amount of fluid to be easily removed from this vial. Draw 10ml’s of water into the syringe. Inject the 10ml’s of Bacteriostatic Water into the powdered vial of hCG.

Gently agitate mixture until dissolved. DO NOT SHAKE!!! Once you mix your medication it must be refrigerated.

Patient Instruction for Injections

1. Wash your hands thoroughly, and dry them with a clean towel.

2. Wipe the rubber stopper on the vial of the HCG with an alcohol pad.

3. Handle the syringe by the barrel only. Do not touch the needle with your hands. Do not let the needle touch any surface.

4. Grasp the syringe by the barrel (not the plunger), and remove the needle cover.

5. Push the needle through the center of the vial’s rubber stopper.

6. Turn the vial and needle/syringe upside down with one hand. Keeping the needle tip below the level of fluid, slowly pull back on the syringe plunger to the desired dose (250 IU’s).

7. If there are any air bubbles, gently tap the syringe barrel until they float to the top of the solution.

8. Holding the syringe upright, push the syringe plunger to the correct volume mark for the dose prescribed by your doctor. This will remove any air and excess solution into the vial.

9. Grasp the syringe barrel (not the plunger) and pull the needle/syringe from the vial of the fluid.

10. Once you have injected your medication as directed, properly dispose of the needle with the syringe in a sharps container. DO NOT RECAP THE NEEDLE.

Do Not Use The Solution If It Is Cloudy Or Contains Particles.

Now You Are Ready For Your Injections

You will be injecting 0.25cc (250 units) every day sub–q until gone (there are 40 injections at this dosage in the bottle).

Open an insulin syringe and pull off the orange cap. Stick the needle gently into the rubber stopper and invert bottle so that the liquid covers the needle. Pull the plunger back until the syringe is filled to the #25 on the syringe.

Pinch (special “K” pinch, love handle) your belly, approximately 3 inches left or right of the belly button and inject.

THE PHARMACY WILL PROVIDE INSTRUCTIONS WITH YOUR HCG KIT. ALWAYS FOLLOW THE INSTRUCTIONS PROVIDED BY THE PHARMACY. IF YOU HAVE ANY QUESTIONS REGARDING THE INSTRUCTIONS, ONCE YOU RECEIVE YOUR KIT, CALL THE NUMBER FOR THE PHARMACY, LOCATED ON YOUR HCG KIT.

MMI Health does not endorse any book, document, or article that promotes hCG or any other product as a weight loss therapy or promise any specific weight loss results. Weight management can be a serious medical condition and everyone should expect varying results without assuming that any program will provide rapid, dramatic, incredible, or magical results. No product, medication, or supplement can guarantee safe weight loss and every weight loss program must follow an approved diet and exercise program. It is for this reason that we recommend and require detailed blood testing, complete medical histories, and exams by physicians prior to pursuing any weight loss therapies.